NOTE - This article is out of date, it may still help other users using UI5 to allow the user of our Recessed Door Sensor Gen5 in older interfaces.
If your Recessed Door Sensor is not working and shows as a ON/OFF application on your Vera interface. Follow the steps below which will guide you through installation and configuration to make this sensor work.
This has been fully tested and confirmed to work on UI7 utilizing Vera Edge.
1) Add as "Generic Device"
1.1) if Vera fails to send security node, then unpair the device and try again.
2) Go to "Advanced" under the Recessed Door Sensor Gen5
3) Device type changed to "urn:schemas-micasaverde-com:device:DoorSensor:1"
Device file changed to "D_DoorSensor1.xml"
Device JSON "D_DoorSensor1.json"
4) The Sensor May or May not disappear, if it disappears then go to
Settings -> Z-Wave Settings -> Advanced Tab
5) Click on "Reload Engine"
6) Close your Vera interface, and open it up again (got to re-log back into your network) and your motion sensor should appear again.
----------
Below are some alternative similar sources that can be followed as well: