This page lists the steps on utilizing Siren 6 with Popp Hub (Z-Wave.me) and forms part of the larger Siren 6 user guide.
Setup your Siren 6
1. Open the Login of your Popphub http://find.popp.eu or http://YOUIPADRESS:8083
2. Add Your PoppHub ID/Username and Password and Login
3. Open the menu (top right) and select devices
4. Press Add new (on the right side) by Z-Wave
5. Press Add new Z-Wave Devices and identify it automatically
6. Following the Steps
1. Reset Device (Exclusion)
Press the button on the device 6x times.
2. Inclusion Press the green Start button
Press the button on the device once
3. Add the PIN for S2 Security and press confirm
(You can find the PIN of the Backside from the device, input value XXXXX) DSK: XXXXX-YYYYY
7. After the inclusion, you can configure your device
Workaround:
To control the individual tones for Siren 6. Follow these steps:
8. Open the menu (top right) and select Apps
9. Under Local Apps select the application HTTP Device and press the green cross
9.1 Change line2 to "switchMultilevel".
9.2 Add the command in line 3.
http://YourIP:8083/ZWave.zway/Run/devices[XXX].instances[0].commandClasses[32].Set($$)
Change YourIP ... IP Adress of PoppHub
Change XXX ... DeviceID of Siren 6
9.3 Set HTTP metod to POST
9.4 Add your PoppHUb Login and Password
9.5 Press Save
10. Now you can find a new device in elements
If you now press the arrow you can play the tones from 1 - 30. If you select a value greater than 30, the last tone will be played.
Troubleshooting:
The interview is not complete
It is possible that there are problems to get the interview complete with single variants.
The following steps explain how to solve this problem:
1. Open the Expert UI http://YOURPOPPHUPIP:8083/expert
2. Choose Device and Status
3. Select your device
4. Press View Interview result
You now see that the AssociationGroupInformation has not been retrieved.
5. Please copy the following line into your browser line and adjust the marked values.
http://IP:8083/ZWave.zway/Run/devices[XXX].instances[YY].commandClasses[89].data.interviewDone.value=true
a. Change IP-Adress (IP)
b. Change Device ID (XXX)
c. Change device Instance (YY)
d. Check the command class
e. Press Enter
Note:
CommandClass 89 = AssociationGroupInformation
Example:
(Instance 1) //Main Siren 6 Node
http://192.168.10.229:8083/ZWave.zway/Run/devices[6].instances[1].commandClasses[89].data.interviewDone.value=true
(Instance 2) //Tamper Node
http://192.168.10.229:8083/ZWave.zway/Run/devices[6].instances[2].commandClasses[89].data.interviewDone.value=true
(Instance 3) // Button #1
http://192.168.10.229:8083/ZWave.zway/Run/devices[6].instances[3].commandClasses[89].data.interviewDone.value=true
f. It is confirmed by "true".
6. Repeat this for all missing instances.
7. The interview must be completed.