Hubitat may not yet have a standard driver yet, so once WallMote 7 is paired, you'll need to change it to a compatible driver to make full use of it. This guide will lead you through connecting your WallMote 7 to your Hubitat hub and will feature:


  • Central Scene
  • Battery




Steps to connect WallMote 7 to Hubitat.

  1. Open your Hubitat interface.
  2. Click on Devices.
  3. Click on Discover Devices.
  4. Click on Z-Wave.
  5. Click on Start Z-Wave Inclusion.
  6. Now tap the Top or Bottom Button once on WallMote 7.
  7. A device box should appear almost immediately, give it about 10 seconds to initialize, feel free to name your device and save this.




How to remove or factory reset WallMote 7 from Hubitat.

  1. Open your Hubitat interface.
  2. Click on Devices.
  3. Click on Discover Devices.
  4. Click on Z-Wave.
  5. Click on Start Z-Wave Exclusion.
  6. Now tap the Top or Bottom Button 6x times in 2 seconds on WallMote 7.
  7. Your Hubitat should tell you if it excluded an unknown device or a specific sensor if it was paired properly previously.




Troubleshooting


Having issues pairing your device?

  • Move your Sensor within 4 - 10 ft of your Hubitat Z-Wave network.
  • Remove power from WallMote 7 for 1 minute, then power it up again. (You must remove both batteries as this device can work with a single battery
  • Try factory resetting or removing your WallMote 7.
    • Remove / Factory Reset first in case the device actually paired to Hubitat otherwise it will leave a phantom device in your network that will be difficult to remove.
    • Perform a manual factory reset - only do this if you are not able to perform the remove steps above.
      1. Press and hold the Action Button for 20 seconds when it is completed, the LED will become solid blue for 2 seconds, and then start to fade a blue color in/out for at least 10 seconds to indicate it is ready to be connected to a new hub.