This guide will leave you through connecting your Door / Window Sensor 7 with Hubitat which will feature these functions for either ZWA011 or ZWA012:


Door / Window Sensor 7 Gen7 (ZWA011)

  • Open/Close status
  • Tamper
  • Battery level


Door / Window Sensor 7 Pro Gen7 (ZWA012)

  • Open/Close status
  • Sensor Operation Mode configuration
    • Internal Magnet Sensor
    • External Terminal Inputs
  • Tamper
  • Battery level





Steps to pair Door/Window Sensor 7 to Hubitat.

  1. Open your Hubitat interface.
  2. Click on Devices.
  3. Click on Discover Devices.
  4. Click on Z-Wave.
  5. Click on Start Z-Wave Inclusion.
  6. Remove the cover of your Door/Window Sensor 7.

     

  7. Now tap the small black tamper switch 3x quickly on Door/Window Sensor 7.



  8. A device box should appear almost immediately, give it about 20 seconds to initialize, feel free to name your device and save this.
  9. Now go to "Devices".
  10. Click on your Door/Window Sensor 7.
  11. Under "Device Information" change Type to "Aeotec Door/Window Sensor 7 Series".
  12. Click on "Save Device".





How to exclude Door/Window Sensor 7 from Hubitat.

  1. Open your Hubitat interface.
  2. Click on Devices.
  3. Click on Discover Devices.
  4. Click on Z-Wave.
  5. Click on Start Z-Wave Exclusion.
  6. Remove the cover of your Door/Window Sensor 7.

     

  7. Now tap the small black tamper switch 3x quickly on Door/Window Sensor 7.



  8. Your Hubitat should tell you if it excluded an unknown device or a specific sensor if it was paired properly previously.





Troubleshooting


Having issues pairing your device?

  • Move your Sensor within 4 - 10 ft of your Hubitat Z-Wave network.
  • Remove power from Door/Window Sensor 7 for 1 minute, then power it up again.
  • Try factory resetting or excluding your Door/Window Sensor 7.
    • Exclude first in case the device actually paired to Hubitat otherwise it will leave a phantom device in your network that will be difficult to remove.
    • Perform a manual hard factory reset
      1. Remove the cover of your Door/Window Sensor 7
      2. Press and hold the tamper switch for 5 seconds until the red LED blinks.
      3. Quickly release the tamper switch, and then immediately press and hold again. 
        • If successful, the LED will display a solid green LED.