Connecting MultiSensor 7 to Home Assistant requires a working installation of that software with Z-Wave management being handled by Aeotec's Z-Stick or any other Z-Wave USB Adapter hardware. Once connected to Z-Wave USB Adapter (ie. Z-Stick) and Home Assistant with Z-WaveJS to MQTT, MultiSensor 7 will offer the following features for either product:


  • Home Security - Motion
  • Air Temperature
  • Humidity
  • Illuminance
  • Ultraviolet
  • Battery Level
  • Low battery level




Steps to connect MultiSensor 7 to Home Assistant.

  1. Open Home Assistant Interface: http://homeassistant:8123/
  2. Click on "Configuration" at the bottom left of the page.
  3. Click on "Integrations".
  4. Click on "Configure" under your Z-Wave JS integration.
  5. Click on "ADD NODE".
  6. Click on "START INCLUSION".
  7. Now tap the Action Button on MultiSensor 7.
  8. Allow about 1-2 minutes to allow your Home Assistant to scan the device information and populate the correct device information about it. 




How to remove or factory reset your MultiSensor 7 from Home Assistant.

  1. Open Home Assistant Interface: http://homeassistant:8123/.
  2. Click on "Configuration" at the bottom left of the page.
  3. Click on "Integrations".
  4. Click on "Configure" under your Z-Wave JS integration.
  5. Click on "REMOVE NODE".
  6. Click on "START EXCLUSION" - Your Home Assistant should start scanning for device button presses.
  7. Now tap the Action Button on MultiSensor 7.
  8. Home Assistant will stop scanning for devices excluded (if not paired), if a device is paired, it will state which device it was removed. Reload the page, and you should notice one less device node under "Nodes ready".




Troubleshooting


Having issues pairing your device?

  • Move your Sensor within 4 - 10 ft of your Home Assistant Z-Wave network.
  • Remove power from MultiSensor 7 for 1 minute, then power it up again.
  • Try factory resetting or excluding your MultiSensor 7.
    • Exclude first in case the device actually paired to Home Assistant otherwise it will leave a phantom device in your network that will be difficult to remove.
    • Perform a manual hard factory reset.
      1. Press and hold the Action Button for 20 seconds until the green LED becomes solid at 20 seconds. If successful, the LED will fade blue in/out for at least 10 seconds to indicate that it is ready to be connected to another hub.